| Author |
Message |
DaveT
Joined: 07 Jan 2008
Posts: 2
|
| Posted: Mon Jan 07, 2008 2:29 pm Post subject: Barco Graphics 801S RGB input 3 |
|
|
Has anyone ever directly input an RGB signal into input 3. Is it strong enough signal to drive?
Thanks Dave
|
|
| Back to top |
|
 |
Person99
Joined: 09 Mar 2006
Posts: 4899
Location: Flower Mound, TX
|
| Posted: Mon Jan 07, 2008 2:54 pm Post subject: Re: Barco Graphics 801S RGB input 3 |
|
|
| DaveT wrote: | | Has anyone ever directly input an RGB signal into input 3. |
Lots of people. If you have not yet, read this:
http://www.curtpalme.com/Barco_Port3_Input.shtm
| DaveT wrote: | Is it strong enough signal to drive?
|
I have no idea what this means.
_________________
Dave
A train station is where the train stops. A bus station is where the bus stops. On my desk, I have a work station....
|
|
| Back to top |
|
|
Curt Palme
CRT Tech
Joined: 08 Mar 2006
Posts: 24396
Location: Langley, BC
TV/Projector: All of them!
|
| Posted: Mon Jan 07, 2008 3:03 pm Post subject: |
|
|
Dave called me the other day and I couldn't remember if the 801 used the later Port 3 board that didn't need the TTL level of drive that the older 800 board did.
THe link above is one page I've never looked at on my site..
So Dave, OP, yes, you're good to go!
|
|
| Back to top |
|
|
Person99
Joined: 09 Mar 2006
Posts: 4899
Location: Flower Mound, TX
|
| Posted: Mon Jan 07, 2008 3:54 pm Post subject: |
|
|
| Curt Palme wrote: | | Dave called me the other day and I couldn't remember if the 801 used the later Port 3 board that didn't need the TTL level of drive that the older 800 board did. |
These things always make me laugh. You can truly say to people, "I've forgot more about CRT PJs than you'll ever know."
| Curt Palme wrote: | THe link above is one page I've never looked at on my site..
|
At the rate Kal was adding helpful pages awhile back, I'm sure it is not the only one.
_________________
Dave
A train station is where the train stops. A bus station is where the bus stops. On my desk, I have a work station....
|
|
| Back to top |
|
|
DaveT
Joined: 07 Jan 2008
Posts: 2
|
| Posted: Mon Jan 07, 2008 5:06 pm Post subject: |
|
|
|
Thanks for the tips. I need to see if the board is installed. Just been lazy about getting up on a ladder.
|
|
| Back to top |
|
|
|
|
