| Author |
Message |
prover
Joined: 07 Nov 2008
Posts: 166
Location: Stuttgart, Germany
|
| Posted: Sun Mar 20, 2011 5:03 pm Post subject: [Solved] SONY 1292 starts but no picture, RC not working |
|
|
I have some probelms starting my 1292. After switching it on the tubes fired up but
no starting screen is showing. I have two IFB11 cards installed and on both the red LED is on.
Somehow the projector seems to stuck in the initialization procedure. No error is shown.
I don't have a clue what could cause these problems.
Is anyone around who has an idea what the problem could be?
Every help is appreciated.
prover
_________________
http://www.bluray-disc.de/blulife/heimkino/prover
Last edited by prover on Mon Apr 18, 2011 9:18 am; edited 1 time in total
|
|
| Back to top |
|
 |
prover
Joined: 07 Nov 2008
Posts: 166
Location: Stuttgart, Germany
|
|
| Back to top |
|
|
prover
Joined: 07 Nov 2008
Posts: 166
Location: Stuttgart, Germany
|
| Posted: Mon Apr 18, 2011 9:22 am Post subject: |
|
|
Well after a lot of search I have found the problem, it was a short in the wired RC. Unfortunately it damaged the SIRCS controller and perhaps other parts on the Y-board. After exchanging the Y-board everything was fine again. Perhaps this is helpfull for someone facing similar problems with the 1292.
Cheers!
_________________
http://www.bluray-disc.de/blulife/heimkino/prover
|
|
| Back to top |
|
|
avwerks
Joined: 14 Oct 2006
Posts: 16
Location: OC ,Calif.
|
| Posted: Mon Apr 18, 2011 4:10 pm Post subject: |
|
|
I remember when I had a couple of 1292's. After a complete cleaning, a small piece of tissue paper had snagged a corner of one fan, smaller than a finger nail and locked a fan. Spent considerable time until I found it!
Regards
David
|
|
| Back to top |
|
|
|
|
