| Author |
Message |
bbfarmht
Joined: 27 May 2006
Posts: 1273
Location: Where the Mississippi runs east to west!!
|
| Posted: Wed Feb 10, 2010 1:56 am Post subject: Neck board Identification |
|
|
Last fall I went down to Texas to visit my uncle. While down there I stumbled on an ex-Barco tech. He had a garage full of barco stuff, and wanted to make room for his wife's new classic Beamer.
So, I came home with a u-haul full of parts. One of these parts is eluding me. I know its a barco neck board, however I cannot find what projector its to. The part number is R7630275-2.
_________________
Adam
"Any society that would give up a little liberty to gain a little security will deserve neither and lose both"
Benjamin Franklin
|
|
| Back to top |
|
 |
Hulio
Joined: 15 Apr 2006
Posts: 494
Location: Belgium
|
| Posted: Wed Feb 10, 2010 11:45 am Post subject: |
|
|
Not bad at all.Those are for BarcoReality 909/Cine 9.Congrats.
Stan
|
|
| Back to top |
|
|
bbfarmht
Joined: 27 May 2006
Posts: 1273
Location: Where the Mississippi runs east to west!!
|
| Posted: Fri Feb 12, 2010 6:01 pm Post subject: |
|
|
| Hulio wrote: | Not bad at all.Those are for BarcoReality 909/Cine 9.Congrats.
Stan |
Thank you Stan,
Where did you find the parts list for those. I had figured that it could be from one of those but was unsure. I had parts list from most of the rest of the Barco projectors.
_________________
Adam
"Any society that would give up a little liberty to gain a little security will deserve neither and lose both"
Benjamin Franklin
|
|
| Back to top |
|
|
Hulio
Joined: 15 Apr 2006
Posts: 494
Location: Belgium
|
| Posted: Sat Feb 13, 2010 9:03 pm Post subject: |
|
|
| bbfarmht wrote: |
Where did you find the parts list for those. I had figured that it could be from one of those but was unsure. I had parts list from most of the rest of the Barco projectors. |
I've got the service manuals for both (BR909/Cine9) projectors.
Stan
|
|
| Back to top |
|
|
|
|
