| Author |
Message |
garysorenson
Joined: 17 Jul 2007
Posts: 63
Location: Milwaukee, Wisconsin
|
| Posted: Wed Dec 17, 2008 6:56 pm Post subject: How do I recap my NEC PG9 (drifting convergence issues) |
|
|
I've redone my setup several times from square 1 and no matter how well my setup is, I still get a drifting between all the colors. Most of the drifting occurs nearest the corners. Itll be fine for a few hours but that's all.
I'm considering replacing the caps as mentioned on this site, so I guess I need to know where to get started.
Thanks All
|
|
| Back to top |
|
 |
Z-Photo
Joined: 07 Mar 2006
Posts: 2749
Location: Huntsville - Alabama
|
| Posted: Wed Dec 17, 2008 7:14 pm Post subject: |
|
|
Speaking from a Barco standpoint -
The best place to start was the large e-caps on the power supply and then the caps on the neckboards.
it can snowball quickly from there.
_________________
Engineer by Day
Photographer by Night
My Portfolio
The Only GOOD AMPRO - is a Dead AMPRO.
wait - are they not all DEAD already?
|
|
| Back to top |
|
|
Mark_A_W
Joined: 15 Mar 2006
Posts: 3068
Location: Sunny Melbourne Australia
|
| Posted: Thu Dec 18, 2008 12:30 am Post subject: |
|
|
Gawd, I'd just buy a newer projector.
The cost of recapping could get out of hand.
|
|
| Back to top |
|
|
|
|
