| Author |
Message |
rbenkler
Joined: 25 Nov 2008
Posts: 17
Location: MN-USA
|
| Posted: Sat Dec 06, 2008 7:01 am Post subject: NEC XG75 |
|
|
Hi All!
Sure can use a bit of assistance.
Is there an easy/simple (hahahaha) method of adjusting the phase? For that matter, if all the focus and alignments appear to be dead-on, does it matter if the phase is not dead-on like the other alignments? Can someone please advise! Thanks in advance for your assistance!!!!!!!!!!!
|
|
| Back to top |
|
 |
Mark_A_W
Joined: 15 Mar 2006
Posts: 3068
Location: Sunny Melbourne Australia
|
| Posted: Sun Dec 07, 2008 12:13 am Post subject: |
|
|
|
Just put the crosshairs in the centre of the screen, and line the bump up with the centre too.
|
|
| Back to top |
|
|
rbenkler
Joined: 25 Nov 2008
Posts: 17
Location: MN-USA
|
| Posted: Sun Dec 07, 2008 2:22 am Post subject: |
|
|
|
Thanks for the reply Mark! It sounds easy enough, however, the crosshairs and phase will not project simultaneously. Is there some method on this projector I am not knowledgeable of that would allow this and to act on your suggestion?
|
|
| Back to top |
|
|
Mark_A_W
Joined: 15 Mar 2006
Posts: 3068
Location: Sunny Melbourne Australia
|
| Posted: Sun Dec 07, 2008 5:18 am Post subject: |
|
|
Eh?
Turn off Red and Blue, they just confuse things.
Hit PHASE and a grid test pattern, with a bump on the middle line will appear.
Line up the centre of the grid (the bit with the crosshairs) with the centre of your screen.
Line up the bump with the crosshairs.
Done.
|
|
| Back to top |
|
|
kschmit2
Joined: 09 Mar 2006
Posts: 1141
Location: Heidelberg, Germany
|
|
| Back to top |
|
|
kschmit2
Joined: 09 Mar 2006
Posts: 1141
Location: Heidelberg, Germany
|
| Posted: Mon Dec 08, 2008 2:36 pm Post subject: |
|
|
hell, I just realized that the post I linked you to was in response to another thread of yours about phase.
I would really appreciate it if you could read responses to your own threads before you start a new one
|
|
| Back to top |
|
|
|
|
