| Author |
Message |
Mark_A_W
Joined: 15 Mar 2006
Posts: 3068
Location: Sunny Melbourne Australia
|
| Posted: Thu Jan 24, 2008 8:50 pm Post subject: |
|
|
When the pot is set to 1.8v, I've never had any trouble getting enough width.
I don't think you need to go further than spec on this.
|
|
| Back to top |
|
 |
Juvental604
Joined: 04 Nov 2007
Posts: 40
|
| Posted: Thu Jan 24, 2008 9:44 pm Post subject: |
|
|
|
OK i did turn it about a quarter or half way and it seems to be fine. The only thing I notice now is that outside of the projected picture there is a faint light border in the raster. Blanking doesnt seem to be getting rid of it. Its like this in all the resolutions I have tried so far. Is this normal? Also Does it matter if this faint light is near the edge of the raster?
|
|
| Back to top |
|
|
Juvental604
Joined: 04 Nov 2007
Posts: 40
|
| Posted: Fri Jan 25, 2008 2:24 am Post subject: |
|
|
Never mind I realized I just had to turn the gains down to get rid of the faint lines around the image.
The only other thing I have noticed is that the projector seems to degauss it self every once in a while.
Not sure if it always did that though.
|
|
| Back to top |
|
|
|
|
