| Author |
Message |
Murillo
Joined: 30 Dec 2007
Posts: 113
Location: Sweden
|
| Posted: Sun Dec 30, 2007 11:15 pm Post subject: H phase dont work on my Barco 808 |
|
|
I moved to a new house and my barco has been packed away four about five months. I took it out yesterday and started to set it up, after i was done with the raster I went over to set the H phase but it didn`t work. No matter how much the numbers (0-99) went up and down, the picture didn`t move the slightest bit. The H phase worked before fine I moved but now the picture is stuck and wont move at all.
Is there somebody who could help me out with this?
Best regards Murillo.
|
|
| Back to top |
|
 |
Ile
Joined: 09 Mar 2006
Posts: 1491
Location: Jyväskylä, Finland
|
| Posted: Mon Dec 31, 2007 1:05 pm Post subject: |
|
|
Do you have same source that last time?
Is there unused raster in both sides off picture?
|
|
| Back to top |
|
|
Tom.W
Joined: 09 Mar 2006
Posts: 6635
|
| Posted: Mon Dec 31, 2007 3:23 pm Post subject: |
|
|
|
You could try deleting all blocks and start from scratch. Never encountered that problem.
|
|
| Back to top |
|
|
Curt Palme
CRT Tech
Joined: 08 Mar 2006
Posts: 24396
Location: Langley, BC
TV/Projector: All of them!
|
| Posted: Mon Dec 31, 2007 3:24 pm Post subject: |
|
|
|
That is indeed strange. I can repair whatever board is defective, but I'd have to look up where the H phase is controlled. Never had that issue either..
|
|
| Back to top |
|
|
Ile
Joined: 09 Mar 2006
Posts: 1491
Location: Jyväskylä, Finland
|
| Posted: Mon Dec 31, 2007 4:40 pm Post subject: |
|
|
| Curt Palme wrote: | | That is indeed strange. I can repair whatever board is defective, but I'd have to look up where the H phase is controlled. Never had that issue either.. |
Bella and amps is probably in vertical deflection board, like in 801s and 120* series...
|
|
| Back to top |
|
|
Murillo
Joined: 30 Dec 2007
Posts: 113
Location: Sweden
|
| Posted: Mon Dec 31, 2007 4:44 pm Post subject: |
|
|
I have the same source as the last time and there is unused raster on both sides. I haven`t tried to delete all blocks. I will try that. Today I`ve noticed that the left side controls don`t work (left side bow and left side keystone), the problem is the same as with H phase.
I will keep you guys posted.
Thanks for your help.
Regards Murillo
|
|
| Back to top |
|
|
Murillo
Joined: 30 Dec 2007
Posts: 113
Location: Sweden
|
| Posted: Tue Jan 01, 2008 1:25 pm Post subject: |
|
|
Hello Guys
I deletet all blocks and set everything to midpoint but it didn`t work. The image still won`t move when I do the H phase. Is something broke on my PJ, and if so what is broken?
|
|
| Back to top |
|
|
|
|
