| Author |
Message |
oliverg
Joined: 15 May 2007
Posts: 800
Location: Melbourne, Australia
TV/Projector: Sony G90 X2 - Vidikron Vision 1
|
| Posted: Thu Oct 18, 2007 4:17 am Post subject: Vidikron Vision 2 case on a 9500 chassis |
|
|
Gentlemen - does anyone know with absolute certainty that the Vision 2 case will fit the Vision 1 with the exception of the facia panel?
I'm thinking of getting Chris's as its a really good buy and postage isn't TOO bad.
I just don't want it to get here and not fit at all, leaving me with 20 kilograms of plastic junk that wouldn't be economical to ship back.
Any advice welcomed
_________________
( R ) G ( G ) 9 ( B ) 0 ( R ) G ( G ) 9 ( B ) 0
( R ) G ( G ) 9 ( B ) 0 ( R ) G ( G ) 9 ( B ) 0
|
|
| Back to top |
|
 |
nuttall_chris
Joined: 08 Mar 2006
Posts: 832
Location: Ottawa, Ontario, Canada
|
| Posted: Thu Oct 18, 2007 12:01 pm Post subject: |
|
|
I know for sure that the case (with the exception of the facia panel) will fit. It came on my Marquee 9500 Ultra and it fits perfectly. The facia panel was shipped to me seperatly from the rest of the projector as it will not fit without major modification.
Chris.
|
|
| Back to top |
|
|
derfla
Joined: 11 Mar 2006
Posts: 547
Location: eastern ohio
|
| Posted: Thu Oct 18, 2007 1:13 pm Post subject: |
|
|
the whole case will fit if you cut out the lens holes I guarantee it. Send it to me I will cut out the holes It is not that hard.
Last edited by derfla on Thu Oct 18, 2007 1:26 pm; edited 1 time in total
|
|
| Back to top |
|
|
derfla
Joined: 11 Mar 2006
Posts: 547
Location: eastern ohio
|
| Posted: Thu Oct 18, 2007 1:15 pm Post subject: |
|
|
|
on a second note. don't think you will simply get a front section from another pj and paint it to match. "This will not work" a front section from another case will not fit.
|
|
| Back to top |
|
|
oliverg
Joined: 15 May 2007
Posts: 800
Location: Melbourne, Australia
TV/Projector: Sony G90 X2 - Vidikron Vision 1
|
| Posted: Thu Oct 18, 2007 1:54 pm Post subject: |
|
|
Thank you for the advice Derfla. You know alot about moulds!!
I'm going to try to make a custom facia panel. Byt for the moment, I'll just use the foam one. No wonder Lelectrohome decided to use foam
Kind regards
_________________
( R ) G ( G ) 9 ( B ) 0 ( R ) G ( G ) 9 ( B ) 0
( R ) G ( G ) 9 ( B ) 0 ( R ) G ( G ) 9 ( B ) 0
|
|
| Back to top |
|
|
|
|
