| Author |
Message |
Thermio
Joined: 15 Jan 2008
Posts: 36
|
| Posted: Mon Sep 27, 2021 4:12 pm Post subject: Barco 909 does not respond to remote |
|
|
Hi guys,
my Barco 909 does not respond to IR remote, onboard remote, or remote connected with cable. It just stopped one day. I could turn it on with the 0 button and to turn off I had to use the power switch.
I limped along like this for a while but now have moved and need to get the remote working for setup. Last time I talked to Curt he said it probably needed a new board but he has not respond in a month or so so I am looking for alternative support.
Any help greatly appreciated.
Cheers,
Chuck
|
|
| Back to top |
|
 |
Curt Palme
CRT Tech
Joined: 08 Mar 2006
Posts: 24396
Location: Langley, BC
TV/Projector: All of them!
|
| Posted: Mon Sep 27, 2021 10:42 pm Post subject: |
|
|
Press the unmarked indented button, then press 0,0,0. Make sure the batteries in the remote are fresh, and do the same thing on the keypad on the projector. That will reset the projector address to 0.
If that doesn't work, then either the main power supply (SMPS) or the controller board is bad. Right now I have neither board in stock, but that may change in a couple of months.
|
|
| Back to top |
|
|
Thermio
Joined: 15 Jan 2008
Posts: 36
|
| Posted: Tue Sep 28, 2021 6:37 am Post subject: Hi Curt |
|
|
Hi Curt, thank you.
IIRC I tried the reset with no effect. I am wondering which board is the controller so I can have a look at it. I had installed the Moome HMDI board around that time and I am wondering if I may have knocked something loose... etc...
Please put me on the list for a contoller board. Since the PJ powers up and works fine once on I am guessing it is not the SMPS?
|
|
| Back to top |
|
|
tanwn1
Joined: 08 Dec 2014
Posts: 60
|
| Posted: Mon Oct 04, 2021 3:36 am Post subject: |
|
|
|
My remote can start projector but once started, no response from remote. What could b issue?
|
|
| Back to top |
|
|
Hulio
Joined: 15 Apr 2006
Posts: 494
Location: Belgium
|
| Posted: Mon Oct 04, 2021 9:04 am Post subject: |
|
|
@tanwn1
You already opened a topic regarding this issue, it is not so polite to hijack Thermio's one.
|
|
| Back to top |
|
|
Dancrt
Joined: 16 Sep 2017
Posts: 88
|
| Posted: Mon Oct 04, 2021 9:37 am Post subject: |
|
|
Probably not either of yous issue but just in case mine wouldn’t work only turn on with inbuilt buttons
I had a bent pin on the cpu board got some super thin pliers that had smooth surface straightened and it was fine after that took ages and asking curt to figure out Good luck
|
|
| Back to top |
|
|
|
|
