| Author |
Message |
RobertR
Joined: 18 Aug 2007
Posts: 14
|
| Posted: Sun Feb 14, 2016 11:28 pm Post subject: NEC XG135LC settings off |
|
|
|
Last week I noticed that I had accidentally left my project on for a week with no input. I watched a movie with no problems, but when I turned it on this weekend, I noticed that the convergence was way off and the picture was tilted. I let it rest for a day and tried it again. It seemed to go back to normal for a few minutes, but then the picture changed to where it's several inches short on the right side. The convergence looks good other than that. Did I fry something?
|
|
| Back to top |
|
 |
gjaky
Joined: 05 Jun 2010
Posts: 2802
Location: Budapest, Hungary
|
| Posted: Mon Feb 15, 2016 7:22 pm Post subject: |
|
|
Is the projector recognizes the preset saved for the actual input, or does it give a *new signal* message? If it recognizes the preset, then try to adjust convergence/ geometry to see if you are missing any range of adjustments?
_________________
projectors in the past : NEC 6-9PG xtra, Electrohome Marquee 6-7500, NEC XG 1351 LC ( with super modified Electrohome VNB neckboard !!!)
current: VDC Marquee 9500LC
The MOD: VNB-DB, VIM-DB
|
|
| Back to top |
|
|
RobertR
Joined: 18 Aug 2007
Posts: 14
|
| Posted: Mon Feb 15, 2016 9:19 pm Post subject: |
|
|
|
It recognizes the preset for the input, but no amount of geometry adjustments fixes the problem.
|
|
| Back to top |
|
|
gjaky
Joined: 05 Jun 2010
Posts: 2802
Location: Budapest, Hungary
|
| Posted: Mon Feb 15, 2016 9:26 pm Post subject: |
|
|
Can you post a picture with the cross-coarse pattern to see what adjustments are off?
_________________
projectors in the past : NEC 6-9PG xtra, Electrohome Marquee 6-7500, NEC XG 1351 LC ( with super modified Electrohome VNB neckboard !!!)
current: VDC Marquee 9500LC
The MOD: VNB-DB, VIM-DB
|
|
| Back to top |
|
|
RobertR
Joined: 18 Aug 2007
Posts: 14
|
| Posted: Mon Feb 15, 2016 9:47 pm Post subject: |
|
|
Here's a pic.
| Description: |
|
| Filesize: |
324.83 KB |
| Viewed: |
2692 Time(s) |
|
|
|
| Back to top |
|
|
gjaky
Joined: 05 Jun 2010
Posts: 2802
Location: Budapest, Hungary
|
| Posted: Tue Feb 16, 2016 4:41 pm Post subject: |
|
|
Red looks to be slightly off, I'd say it's the C-drive board then, but a major failure usualy throw an error code.
_________________
projectors in the past : NEC 6-9PG xtra, Electrohome Marquee 6-7500, NEC XG 1351 LC ( with super modified Electrohome VNB neckboard !!!)
current: VDC Marquee 9500LC
The MOD: VNB-DB, VIM-DB
|
|
| Back to top |
|
|
|
|
