| Author |
Message |
schmoe
Joined: 30 Mar 2008
Posts: 374
Location: Seattle, WA
|
| Posted: Fri Jun 19, 2009 5:57 pm Post subject: How to set contrast setting on Moome card (VIM-FULLHD) |
|
|
Hi,
Are there any resources on properly adjusting the contrast knob on the Moome cards? If not, any advice you can share? I understand the gamma knob, and I'll be tweaking that this weekend as I do my grayscale calibration (thanks to Kal's guide!). But not sure what to do with the contrast knob or how to know if it's set correctly. Just got the Moome card and I haven't moved it from it's default/shipped position.
Thanks,
Joe
|
|
| Back to top |
|
 |
schmoe
Joined: 30 Mar 2008
Posts: 374
Location: Seattle, WA
|
| Posted: Sun Jun 21, 2009 11:17 pm Post subject: |
|
|
|
Anyone?
|
|
| Back to top |
|
|
Nashou66
Joined: 12 Jan 2007
Posts: 16171
Location: West Seneca NY
|
| Posted: Mon Jun 22, 2009 1:43 am Post subject: |
|
|
You turn it counter clockwise to max it out. A 100 IRE field should be .7v the contrast adjustor will allow you to go to 1 v. you need to measure this at the mini rca jack on the vim or at the end of the mini rca cable connector that goes to the VNB. id leave it alone unless you find that 100 IRE is not .7v at the end of the rca connector. then you would raise it till 100IRE is .7 v unless you want it bit higher for some reason.
Athanasios
_________________
Don't blame your underwear for your crooked ass~ unknown Greek philosopher
"Republicans believe every day is the Fourth of July, but the Democrats believe every day is April 15." --- President Reagan
One Smart Dog!!!
Marquee High Performance Bellows now shipping!!
Marquee Modifications and Performance Enhancement
Marquee C-element and Bellow removal
|
|
| Back to top |
|
|
schmoe
Joined: 30 Mar 2008
Posts: 374
Location: Seattle, WA
|
| Posted: Mon Jun 22, 2009 1:48 am Post subject: |
|
|
Thanks. That sounds like a bit outside my comfort zone so I'll leave it alone for now. 
|
|
| Back to top |
|
|
|
|
