| Author |
Message |
fishlogan
Joined: 02 Jan 2008
Posts: 14
|
| Posted: Mon Mar 30, 2009 1:30 am Post subject: marquee 9500lc frequency block question |
|
|
not sure if this is a normal oddity with marquees but when i dial in a certain resolution at say 1080p 48hz then switch to 72 hz (which changes the frequency block from low to high) my centering is out.
all the geometry etc is fine but my red and blue rasters are shifted up. red by about 1cm, blue by about 2 cm. this is only in the vertical plane
i can use recal memories to have different memories for the low or high frequency block but its still a bit of a pain
is this normal? or is it a certain board that might need a little maintenance and if so which one?
everything is mechanically dialled in pretty well
my unit is a 9500lc ultra
|
|
| Back to top |
|
 |
Nashou66
Joined: 12 Jan 2007
Posts: 16171
Location: West Seneca NY
|
|
| Back to top |
|
|
tse
Joined: 03 May 2006
Posts: 1014
Location: Sweatbucket, Fl.
|
| Posted: Mon Mar 30, 2009 2:25 am Post subject: |
|
|
There isn't a good reason for what you describe happening. It sounds like the CPU is switching to a different recall channel because of the different scan frequencies. Try turning off the automatic functions. My best guess as to why things change from one format to another....
Scott
_________________
"Were we directed from Washington when to sow and when to reap, we would soon want bread."
Thomas Jefferson
|
|
| Back to top |
|
|
|
|
