| Author |
Message |
moby
Joined: 18 Nov 2008
Posts: 64
|
| Posted: Fri Jan 23, 2009 8:29 pm Post subject: problems during calibration |
|
|
Hi everyone. I had my technician work on marquee 9500 and we experienced a couple of problems.
Things that we experienced when installing the projector:
When using the HDMI input, the picture was overscanned In both sides with no possibility to get it right.
The picture was bigger than the picture, and it was possible to move the picture inside the picture.
It looks like a blanking problem, but all blanking was off.
It was not possible via the remote to get In touch with any setup or adjustment on the HDMI board.
When going SD in via the component input, there was no overscan.
Any advice is appreciated!
_________________
http://www.curtpalme.com/forum/viewtopic.php?p=171911
|
|
| Back to top |
|
 |
Clarence
Joined: 08 Mar 2006
Posts: 3827
Location: Smith Mtn Lake, VA
|
| Posted: Fri Jan 23, 2009 9:31 pm Post subject: |
|
|
What was the source?
What are you using for HDMI conversion?
|
|
| Back to top |
|
|
moby
Joined: 18 Nov 2008
Posts: 64
|
| Posted: Sat Jan 24, 2009 4:36 pm Post subject: |
|
|
im using a VIM hdmi card with a gamma x remote which was bought from curtpalme.com. It only has 1 hdmi input and component input!
the source is a vp50 linedoubler which is connected to a bluray player!
_________________
http://www.curtpalme.com/forum/viewtopic.php?p=171911
|
|
| Back to top |
|
|
moby
Joined: 18 Nov 2008
Posts: 64
|
|
| Back to top |
|
|
|
|
